Engineering and Quality

Direct all quality questions to our quality manager: Jeff Bleed at

Our cutting-edge engineering software can extract XYZs and LRAs from your 3D models.

In most cases, depending on the complexity of the part, we do require 3D .STEP files, or .IGES files. If the part is complex and you don’t have a 3D file, we can do it for you.

All parts are checked with our ROMER Arm during the initial setup by our bending tech staff on each job. We adjust all parts during the setup phase until they meet your tolerances. After that, we check parts for consistency at whatever frequency you require or as necessary to ensure all parts remain within tolerance. We will recommend a tolerance-check frequency at your request.

We do offer PPAP and FAI services for all jobs, which incurs a higher cost due to setup work. We supply our customers with supporting documentation for the material certs and the bending data from the ROMER Arm when requested.

If you have a hydraulic line (or any part for that matter) that needs to be replaced, and you don’t have a print, we can reverse-engineer the part with our ROMER Arm and make an exact replacement part for you.